Chevrolet 2004 Tahoe Spezifikationen Seite 230

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 548
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 229
SERVICE TIRE MONITOR
If your vehicle is equipped with the Tire Pressure
Monitor System, this message will be displayed if one or
more of the tire monitor sensors have malfunctioned,
or if all of the tire monitor sensors have not been
programmed successfully. Press the select button or
reset stem, to clear it from the display. The message will
reappear at each ignition cycle until the system has
been serviced.
STABILITY SYS ACTIVE
You may see the STABILITY SYS ACTIVE message on
the DIC. It means that an advanced computer-controlled
system has come on to help your vehicle continue to
go in the direction in which you’re steering. Stabilitrak
®
activates when the computer senses that your vehicle
is just starting to spin, as it might if you hit a patch of ice
or other slippery spot on the road. When the system
activates, you may hear a noise or feel a vibration in the
brake pedal. This is normal. When the STABILITY
SYS ACTIVE message is on, you should continue to
steer in the direction you want to go. The system
is designed to help you in bad weather or other difficult
driving situations by making the most of whatever
road conditions will permit.
STABILITY SYS DISABLED
The STABILITY SYS DISABLED message will turn on
when you press the Stabilitrak
®
button, or when the
stability control has been automatically disabled. To limit
wheel spin and realize the full benefits of the stability
enhancement system, you should normally leave
Stabilitrak
®
on. However, you should turn Stabilitrak
®
off
if your vehicle gets stuck in sand, mud, ice or snow
and you want to “rock” your vehicle to attempt to free it,
or if you are driving in extreme off-road conditions
and require more wheel spin. See If You Are Stuck:
In Sand, Mud, Ice or Snow on page 4-52. To turn the
Stabilitrak
®
system back on press the Stabilitrak
®
button
again. There are four conditions that can cause this
message to appear. One condition is overheating, which
could occur if Stabilitrak
®
activates continuously for
an extended period of time. The message will also be
displayed if the brake system warning light is on.
See Brake System Warning Light on page 3-45.
The message could be displayed if the stability system
takes longer than usual to complete its diagnostic
checks due to driving conditions. Also, if an engine or
vehicle related problem has been detected, and the
vehicle needs service, the message will appear.
The message will turn off as soon as the conditions that
caused the message to be displayed are no longer
present.
3-74
Seitenansicht 229
1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 547 548

Kommentare zu diesen Handbüchern

Keine Kommentare