Chevrolet 2008 Impala Spezifikationen PDF herunterladen (Seite 195)

Finding a Station

BAND: Press to switch between FM1, FM2, AM, or

XM™ (if equipped). The selection displays.

f (Tune): Turn to select radio stations.

or the next station and stay there.

To scan stations, press and hold either arrow for a few

seconds until the radio beeps once. The radio goes

to a station, plays for a few seconds, then goes to the

next station. Press either arrow again to stop scanning.

The radio seeks and scans stations only with a

strong signal that are in the selected band.

4 (Information) (Radio with CD (Base)): Press to

switch the display between the radio station frequency

and the time. While the ignition is off, press to display

the time.

4 (Information) (With XM™ Satellite Radio Service,

MP3, and RDS Features): Press to display additional

text information related to the current FM-RDS or

XM™ station, or MP3 song. A choice of additional

information such as: Channel, Song, Artist, and

CAT (category) can appear. Continue pressing to

highlight the desired label, or press the pushbutton

positioned under any one of the labels and the

information about that label displays.

When information is not available, No Info displays.

Setting Preset Stations

(Radio with CD (Base))

If your radio does not have XM™, up to 18 stations

(six FM1, six FM2, and six AM), can be programmed

on the six numbered pushbuttons, by performing

the following steps:

1. Turn the radio on.

2. Press BAND to select FM1, FM2, or AM.

3. Tune in the desired station.

4. Press and hold one of the six numbered

pushbuttons for three seconds until a beep sounds.

When that pushbutton is pressed and released,

the station that was set, returns.

5. Repeat the Steps 2 through 4 for each pushbutton.

3-71

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 399 400

Keine Kommentare

Chevrolet 2008 Impala Spezifikationen Seite 195