Chevrolet 2007 Avalanche Spezifikationen PDF herunterladen (Seite 108)

Starting Procedure

1. With your foot off the accelerator pedal, turn the

ignition key to START. When the engine starts,

let go of the key. The idle speed will go down as

your engine gets warm. Do not race the engine

immediately after starting it. Operate the engine and

transmission gently to allow the oil to warm up

and lubricate all moving parts.

Your vehicle has a Computer-Controlled Cranking

System. This feature assists in starting the engine

and protects components. If the ignition key is turned

to the START position, and then released when the

engine begins cranking, the engine will continue

cranking for a few seconds or until the vehicle starts.

If the engine does not start and the key is held in

START for many seconds, cranking will be stopped

after 15 seconds to prevent cranking motor damage.

To prevent gear damage, this system also prevents

cranking if the engine is already running. Engine

cranking can be stopped by turning the ignition

switch to the ACC/ACCESSORY or LOCK/OFF

position.

Notice: Cranking the engine for long periods of

time, by returning the key to the START position

immediately after cranking has ended, can overheat

and damage the cranking motor, and drain the

battery. Wait at least 15 seconds between each try,

to let the cranking motor cool down.

2. If the engine does not start after 5-10 seconds,

especially in very cold weather (below 0°F or

−18°C), it could be ﬂooded with too much gasoline.

Try pushing the accelerator pedal all the way to

the ﬂoor and holding it there as you hold the key in

START for up to a maximum of 15 seconds.

Wait at least 15 seconds between each try, to allow

the cranking motor to cool down. When the

engine starts, let go of the key and accelerator. If

the vehicle starts brieﬂy but then stops again, do the

same thing. This clears the extra gasoline from

the engine. Do not race the engine immediately

after starting it. Operate the engine and

transmission gently until the oil warms up and

lubricates all moving parts.

Notice: The engine is designed to work with the

electronics in your vehicle. If you add electrical

parts or accessories, you could change the way the

engine operates. Before adding electrical equipment,

check with your dealer/retailer. If you do not, your

engine might not perform properly. Any resulting

damage would not be covered by your vehicle’s

warranty.

2-32

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 513 514

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2007 Avalanche Spezifikationen Seite 108

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto-Videosysteme Chevrolet 2007 Avalanche