Chevrolet 2006 Epica Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Autos Chevrolet 2006 Epica herunter. GM Drive by Wire Throttle Body Cleaning Procedure and Relearn Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Technical Support Bulletin
TO: NAPA Distribution Centers
FROM: Roland Bell
Technical Support / Product Development
ETECH Automotive Chemicals, Inc.
Office: 610-838-8064 ext. 103
Cell: 484-894-9429
DATE: 4-29-2009
SUBJECT: GM Drive by Wire Throttle Body Cleaning Procedure and Relearn Procedures
---------------------------------------------------------------------------------------------------------------------------------------------------
I have been receiving a lot of calls at the Tech Support Line about proper throttle body cleaning
procedures on various vehicles. Please find the first in a series of Manufacturer’s Recommended
Procedures.
For the model year 2007, GM has 66 named vehicles, not including Isuzu, Saab, and Suzuki im-
ports. There is no wonder there is confusion out there. While the cleaning procedure is pretty normal
across the board with GM, there are 6 different relearn procedures listed, and a lot that require no relearn
at all. Below is the procedure for cleaning. The following pages include a list by name of which proce-
dures to use. This is a comprehensive list for the model year 2007. Older or newer vehicles could differ.
Throttle Body Cleaning
Important: Over extended time and mileage, deposits may accumulate on the back of the throttle
valve plate. The source of the deposit is exhaust gas recirculation (EGR) gas. Typically these depos-
its pose no problem. Occasionally the deposit may accumulate to a point where perceived pedal ef-
fort or throttle valve movement is effected. This procedure should not be performed on vehicles with
mileage under 80 450 km (50,000 mi).
1. Remove the air intake duct. Refer to Air Cleaner Inlet Duct Replacement .
Caution: Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected
movement of the throttle blade could cause personal injury.
Notice: Do not insert any tools into the throttle body bore in order to avoid damage to the
throttle valve plate.
2. Inspect the throttle body bore and the throttle valve plate for deposits. You will need to open
the throttle valve in order to inspect all surfaces.
Notice: Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may
damage fuel system components.
3. Clean the throttle body bore and the throttle valve plate using a clean shop towel with ETech
Chemicals ET110 Throttle Body Cleaner.
4. Install the air intake duct. Refer to Air Cleaner Inlet Duct Replacement.
5. Perform the Throttle Learn Procedure. Refer to Throttle Learn.
Bulletin # ETI 4M09 4 page 1 of 8
Seitenansicht 0
1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Technical Support Bulletin

Technical Support Bulletin TO: NAPA Distribution Centers FROM: Roland Bell Technical Support / Product Development ETECH Automotive Chemical

Seite 2 - GM Relearn Procedure List

CarName: Carline4thDigit Truckline5thDigit Procedure Notes:Acadia R/V 4Allure WNoProcedureListedAntara C NoProcedureListed

Seite 3

Bulletin # ETI 4M09 4 page 3 of 8 CarName: Carline4thDigit Truckline5thDigit Procedure Notes:Rainier S/T NoProcedureListedRelay U

Seite 4

Procedure 1 Throttle/Idle Learn The Idle Learn Procedure listed below must be performed whenever the following occurs: • The throttle bo

Seite 5 - Manual Transmission

Bulletin # ETI 4M09 4 page 5 of 8 Procedure 3 Throttle/Idle Learn Anytime the PCM or the battery is disconnected, the PCM looses power, or the P

Seite 6 - Throttle Learn

Bulletin # ETI 4M09 4 page 6 of 8 Procedure 4 Throttle/Idle Learn Description The engine control module (ECM) learns the idle position of the t

Seite 7 - (Feb 17, 2009)

Bulletin # ETI 4M09 4 page 7 of 8 TSB 1 - #PIP4578: Incorrect Idle DTC P0507 And/Or Tip In Hesita-tion After Throttle Body Or ECM Related Repairs

Seite 8

Bulletin # ETI 4M09 4 page 8 of 8 TSB 2 - #06-06-04-032A: Info - Electronic Throttle Control (ETC) Adaptive Value Reset (Idle Learn) Proce-dur

Kommentare zu diesen Handbüchern

Keine Kommentare