Chevrolet Air Conditioner Camaro Bedienungsanleitung

A/C-HEATER SYSTEM - MANUAL 2001 Chevrolet Camaro 2000-01 MANUAL A/C-HEATER SYSTEMS General Motors Chevrolet; Camaro

position. If blower operates in any position, problem is intermittent.Check for poor connections. loose components or damaged wiring. Repairor replace

switch in VENT position. Set blower motor switch in lowest speedposition. Using test light connected to ground, probe blower motorresistor harness con

1) Perform DIAGNOSTIC SYSTEM TEST. Go to next step. 2) Turn ignition switch to ON position. Set mode switch toVENT position. Turn blo

14) Check Light Green wire between A/C-heater control panelharness connector C2 terminal "B" and blower motor switch harnessconnect

Removal (5.7L Engine) Disconnect negative battery cable. Discharge A/C system,using approved refrigerant recovery/recycling equipment

2) Raise and support vehicle. Remove compressor and condenserhose assembly fitting at condenser. Discard "O" ring. Lower vehicle.Re

Fig. 3: Exploded View Of A/C-Heater AssemblyCourtesy of General Motors Corp. Installation 1) To install, reverse removal procedure. T

screen to new evaporator. Using appropriate adhesive, install NEWevaporator core gasket in same position as original. Slide newevaporator to right unt

ring, as this will cause it to expand. Insert short screen end oforifice tube first. Evacuate, charge, and leak test A/C system. TORQUE SPECIF

Fig. 4: Manual A/C-Heater System Wiring Diagram (2000 Camaro &Firebird With 3.8L Engine)

some of the air is recirculated through the A/C system. A/C Conditioned air is directed through dash registers. Bi-Level

Fig. 5: Manual A/C-Heater System Wiring Diagram (2000 Camaro &Firebird With 5.7L Engine)

Fig. 6: Manual A/C-Heater System Wiring Diagram (2001 Camaro &Firebird With 3.8L Engine)

Fig. 7: Manual A/C-Heater System Wiring Diagram (2001 Camaro &Firebird With 5.7L Engine)A00063334

1) Remove right instrument panel sound insulator. Removetemperature control cable from heater housing. Move temperaturecontrol knob from full

NOTE: For additional trouble shooting information, see MANUAL A/C-HEATER SYSTEMS - TROUBLE SHOOTING article. BLOWER MOTOR 1

Ambient Temp. High Pressure Low Pressure F ( C) psi (kg/cm ) psi (kg/cm )70-80 (21-2

A/C SYSTEM PERFORMANCE TEMPERATURE SPECIFICATIONS (2001 MODELS)Ambient Temp. F ( C) Center Vent Temp. F ( C)70-80 (21-27) (1)

relay harness connector terminal B2 (Dark Blue wire). If test lightilluminates, go to next step. If test light does not illuminate, go tostep 6).

14) Operate blower system to verify repair. If blower motoroperates normally, repair is complete. If blower motor is stillinoperative, return

harness connector terminal B2 (Dark Blue wire) and C1 (Purple wire).Turn ignition switch to ON position. Set mode selector switch to VENTposition. Pla