Chevrolet 2005 Malibu Spezifikationen PDF herunterladen (Seite 107)

Keep the original transmitter for use in other vehicles

as well as for future HomeLink

programming. It is also

recommended that upon the sale of the vehicle, the

programmed HomeLink

buttons should be erased

for security purposes. Refer to “Erasing HomeLink

Buttons” or, for assistance, contact HomeLink

on the internet at: www.homelink.com or by

calling 1-800-355-3515.

Be sure that people and objects are clear of the garage

door or gate operator you are programming. When

programming a garage door, it is advised to park outside

of the garage.

It is recommended that a new battery be installed in

your hand-held transmitter for quicker and more

accurate transmission of the radio frequency.

Programming HomeLink

Your vehicle’s engine should be turned off while

programming the transmitter. Follow these steps to

program up to three channels:

1. Press and hold down the two outside buttons,

releasing only when the indicator light begins to

ﬂash, after 20 seconds. Do not hold down the

buttons for longer than 30 seconds and do not

repeat this step to program a second and/or

third transmitter to the remaining two HomeLink

buttons.

2. Position the end of your hand-held transmitter

about 1 to 3 inches (3 to 8 cm) away from the

HomeLink

buttons while keeping the indicator

light in view.

3. Simultaneously press and hold both the desired

button on HomeLink

and the hand-held transmitter

button. Do not release the buttons until Step 4

has been completed.

Some entry gates and garage door openers may

require you to substitute Step 3 with the procedure

noted in “Gate Operator and Canadian

Programming” later in this section.

4. The indicator light will ﬂash slowly at ﬁrst and then

rapidly after HomeLink

successfully receives the

frequency signal from the hand-held transmitter.

Release both buttons.

5. Press and hold the newly-trained HomeLink

button

and observe the indicator light.

If the indicator light stays on constantly,

programming is complete and your device should

activate when the HomeLink

button is pressed and

released.

To program the remaining two HomeLink

buttons,

begin with Step 2 under “Programming HomeLink

.”

Do not repeat Step 1 as this will erase all of the

programmed channels.

2-37

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 409 410

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2005 Malibu Spezifikationen Seite 107

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DVD Spieler Chevrolet 2005 Malibu