Chevrolet Equinox 2006 Spezifikationen PDF herunterladen (Seite 114)

To program the new additional key do the

following:

1. Verify that the new key has a

1 stamped on it.

2. Insert the original, already programmed, key in

the ignition and start the engine. If the engine

will not start, see your dealer for service.

3. After the engine has started, turn the key to

LOCK, and remove the key.

4. Insert the new key to be programmed and turn

it to the RUN position within ﬁve seconds of

removing the original key.

5. The security light will turn off once the key

has been programmed.

6. Repeat Steps 1 through 5 if additional keys

are to be programmed.

If you are driving and the security light comes on

and stays on, you may be able to restart your

engine. Your PASS-Key

®

III+ system, however,

may not be working properly and must be serviced

by your dealer.

If you lose or damage your PASS-Key

®

III+ key,

see your dealer or a locksmith who can service

PASS-Key

®

III+ to have a new key made.

Starting and Operating

Your Vehicle

New Vehicle Break-In

Notice: Your vehicle does not need an

elaborate break-in. But it will perform better in

the long run if you follow these guidelines:

• Do not drive at any one constant speed,

fast or slow, for the ﬁrst 500 miles (805 km).

Do not make full-throttle starts. Avoid

downshifting to brake, or slow, the vehicle.

• Avoid making hard stops for the ﬁrst

200 miles (322 km) or so. During this time

your new brake linings are not yet broken

in. Hard stops with new linings can mean

premature wear and earlier replacement.

Follow this breaking-in guideline every

time you get new brake linings.

• Do not tow a trailer during break-in. See

Towing a Trailer on page 322 for the trailer

towing capabilities of your vehicle and

more information.

Following break-in, engine speed and load

can be gradually increased.

114

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 491 492

Kommentare zu diesen Handbüchern

Keine Kommentare