Chevrolet Equinox 2006 Spezifikationen PDF herunterladen (Seite 117)

If the engine does not start and the key is held

in START for many seconds, cranking will be

stopped after 15 seconds to prevent cranking

motor damage. To prevent gear damage, this

system also prevents cranking if the engine is

already running. Engine cranking can be

stopped by turning the ignition switch to

the ACC or LOCK position.

Notice: Cranking the engine for long periods

of time, by returning the key to the START

position immediately after cranking has ended,

can overheat and damage the cranking motor,

and drain the battery. Wait at least 15 seconds

between each try, to allow the cranking motor

to cool down.

2. If the engine does not start after 5-10 seconds,

especially in very cold weather (below 0°F

or −18°C), it could be ﬂooded with too

much gasoline. Try pushing the accelerator

pedal all the way to the ﬂoor and holding

it there as you hold the key in START

for up to a maximum of 15 seconds.

Wait at least 15 seconds between each try,

to allow the cranking motor to cool down.

When the engine starts, let go of the key

and accelerator. If the vehicle starts brieﬂy

but then stops again, do the same thing.

This clears the extra gasoline from the engine.

Do not race the engine immediately after

starting it. Operate the engine and transaxle

gently until the oil warms up and lubricates

all moving parts.

Notice: Your engine is designed to work with

the electronics in your vehicle. If you add

electrical parts or accessories, you could

change the way the engine operates. Before

adding electrical equipment, check with your

dealer. If you do not, your engine might not

perform properly. Any resulting damage would

not be covered by your vehicle’s warranty.

117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 491 492

Kommentare zu diesen Handbüchern

Keine Kommentare