Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Spezifikationen PDF herunterladen (Seite 175)

Compass Calibration

The compass can be manually calibrated. Only calibrate

the compass in a magnetically clean and safe location,

such as an open parking lot, where driving the vehicle

in circles is not a danger. It is suggested to calibrate

away from tall buildings, utility wires, manhole covers,

or other industrial structures, if possible.

If CAL should ever appear in the DIC display, the

compass should be calibrated.

If the DIC display does not show a heading, for

example, N for North, or the heading does not change

after making turns, there may be a strong magnetic ﬁeld

interfering with the compass. Such interference may be

caused by a magnetic CB or cell phone antenna mount, a

magnetic emergency light, magnetic note pad holder, or

any other magnetic item. Turn off the vehicle, move the

magnetic item, then turn on the vehicle and calibrate the

compass.

To calibrate the compass, use the following procedure:

Compass Calibration Procedure

1. Before calibrating the compass, make sure the

compass zone is set to the variance zone in

which the vehicle is located. See “Compass

Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window,

sunroof, climate controls, seats, etc. during

the calibration procedure.

2. Press the vehicle information button until

PRESS

V TO CALIBRATE COMPAS (Compass)

displays.

3. Press the set/reset button to start the compass

calibration.

4. The DIC will display CALIBRATING: DRIVE IN

CIRCLES. Drive the vehicle in tight circles at less

than 5 mph (8 km/h) to complete the calibration.

The DIC will display CALIBRATION COMPLETE

for a few seconds when the calibration is complete.

The DIC display will then return to the

previous menu.

3-51

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 433 434

Keine Kommentare

Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Spezifikationen Seite 175