Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Spezifikationen Seite 192

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 434
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 191
While your vehicle is parked:
Familiarize yourself with all of its controls.
Familiarize yourself with its operation.
Set up your audio system by presetting your
favorite radio stations, setting the tone, and
adjusting the speakers. Then, when driving
conditions permit, you can tune to your favorite
radio stations using the presets and steering wheel
controls if the vehicle has them.
Notice: Before adding any sound equipment to
your vehicle, such as an audio system, CD player,
CB radio, mobile telephone, or two-way radio, make
sure that it can be added by checking with your
dealer/retailer. Also, check federal rules covering
mobile radio and telephone units. If sound equipment
can be added, it is very important to do it properly.
Added sound equipment may interfere with the
operation of your vehicle’s engine, radio, or other
systems, and even damage them. Your vehicle’s
systems may interfere with the operation of sound
equipment that has been added.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, the audio system can be played
even after the ignition is turned off. See Retained
Accessory Power (RAP) on page 2-22 for more
information.
Setting the Time
Without Date Display
AM/FM Base Radio with a
Single CD Player
This type of radio has a H (clock) button for setting the
time. Set the time by following these steps:
1. Turn the radio on.
2. Press the
H button until the hour begins flashing
on the display. Press the
H button a second time
and the minutes begin flashing on the display.
3. While either the hour or the minutes are flashing, turn
the
f (tune) knob, located on the upper right side of
the radio, clockwise or counterclockwise to increase
or decrease the time. Instead of using the
f knob,
you can also press the SEEK arrows,
\ FWD
(forward), or
s REV (reverse) buttons to adjust
the time.
4. Press the
H button again until the clock display
stops flashing to set the currently displayed time;
otherwise, the flashing stops after five seconds and
the current time displayed is automatically set.
3-68
Seitenansicht 191
1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 433 434

Kommentare zu diesen Handbüchern

Keine Kommentare