97. Using the 1” hole saw again, create one or
two holes in the right hand splash panel below
the radiator. This is where the coolant lines will
pass through to the heat exchanger.
98. Install the intercooler cap onto the reservoir
and then place the reservoir on top of the vehicle
battery. Note: The locations of the inlet and outlet
barbs.
99. Using the length of 3/4” hose supplied, install
one end on the outlet barb of the reservoir and
route it under the fuse relay center and along the
frame down to the coolant pump. The complete
routing of all the hose is shown.
100. Cut the hose to length and connect the
hose to the inlet barb of the pump. Secure both
ends of the hose with the spring clamps supplied.
Outlet
Pump
Inlet
Outlet
Coolant hose
to pump
RESERVOIR
Outlet
Inlet
2 X 1.00” Holes
Hose to water manifold
2005-2007 C6 LS2 Corvette
Kommentare zu diesen Handbüchern