Chevrolet 2500HD Bedienungsanleitung Seite 88

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 130
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 87
Black plate (12,1)
DURAMAX Diesel Engine (LML/LGH) - 2011
10-12 Vehicle Care
Checking the Fluid Level
Prepare the vehicle as follows:
.
Park the vehicle on a level
place. Keep the engine running.
.
With the parking brake applied,
place the shift lever in P (Park).
.
With foot on the brake pedal,
run the engine for at least
one minute and shift to D (Drive).
Then shift to N (Neutral) and
then R (Reverse) to fill the
hydraulic system. Then, put
the shift lever in P (Park).
.
Allow the engine to run at idle
(500 800 rpm). Slowly release
the brake pedal.
Then, without shutting off the
engine, follow these steps:
Cold Check Procedure
The purpose of the cold check is to
determine if the transmission has
enough fluid to be operated safely
until a hot check can be made. The
fluid level rises as fluid temperature
increases. DO NOT fill above the
COLD CHECK band if the
transmission fluid is below normal
operating temperatures.
1. Pull out the dipstick and wipe
it with a clean rag or paper
towel. The transmission dipstick
is located near the center of
the engine compartment.
See Engine Compartment
Overview on page 104 for
more information on location.
2. Push it back in all the way, wait
3 seconds and then pull it back
out again.
3. Check the fluid level reading.
Repeat the check procedure to
verify the reading.
4. If the fluid level is within the
COLD CHECK band, the
transmission may be operated
until the fluid is hot enough to
perform a hot check. If the fluid
level is not within the COLD
CHECK band, add or drain fluid
as necessary to bring the level
into the middle of the COLD
CHECK band.
5. Perform a hot check at the
first opportunity after the normal
operating temperature of 71°C
(160°F) to 93°C (200°F) is
reached.
6. If the fluid level is in the
acceptable range, push the
dipstick back in all the way.
Hot Check Procedure
The fluid must be hot to ensure an
accurate check. The fluid level rises
as temperature increases.
1. Operate the transmission in
D (Drive) until the normal
operating temperature of 71°C
(160°F) to 93°C (200°F) is
reached.
2. Pull out the dipstick and wipe it
with a clean rag or paper towel.
3. Push it back in all the way, wait
three seconds and then pull it
back out again. Repeat the
check procedure to verify the
reading.
Seitenansicht 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 129 130

Kommentare zu diesen Handbüchern

Keine Kommentare