Chevrolet 1995 S10 Pickup Bedienungshandbuch Seite 145

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 380
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 144
Lower Knob (TUNE-AM-FM)
-
The lower knob has two functions:
0
Turn
it
to tune
in
radio stations.
0
Press it
to
change between the AM and
FM
bands.
FADE
-
The control ring behind the lower knob adjusts the fronthear
speaker balance.
SEEK
-
Press the
SEEK
button to cause the receiver to
SEEK
the next
higher station and stop.
SCAN
-
Press the SCAN button to hear each station for a
few
seconds.
Push it again
when
you reach the station
you
want to listen to and the radio
will stop scanning.
“SCAN”
appears in the display.
Pushbuttons
-
The four pushbuttons let you return to favorite stations. To
set the pushbuttons for
up
to fourteen favorite stations
(7
AM and
7
FM):
1.
Tune in the desired station.
2.
Push the
SET
button.
“SET”
appears
in
the display for about
5
seconds.
3.
Within the
5
seconds, push one of the four pushbuttons. Whenever you
press that button, the preset station will return.
NOTE:
In addition to the four stations set as above, up to three additional stations
may be preset on each band by pressing
two
adjoining pushbuttons at the
same time. Then do the following:
1.
Tune in the desired station.
2.
Press the
SET
button.
3.
Within
5
seconds, press any
two
adjoining pushbuttons at the same time.
(The station will return when the same
two
buttons are pressed again.)
Adjust the Tone
-
Use the levers
in
the upper middle left corner to set the
bass, midrange, and treble until you get the sound
you
want. The
60
and
250
levers adjust the bass,
1
K
is midrange, and
3
.X
and
1
OK
control the treble.
We suggest you start with the center lever
(1K)
in the midpoint position,
then move the others up until
you
get the amount of bass and treble
you
like.
Am-St Button
-
The Am-St button is just below the SEARCH button.
Push this when
you
tune
to
an AM station that broadcasts in stereo. Your
STEREO
light will come on when you’re receiving AM stereo. If you push
Am-St and there is
no
more noise, it means the station is weak.
You’ll
hear
the station better if you don’t use Am-St. Just push the Am-St button again
to delete stereo.
AUTO DNR@
-
This unit is equipped with an automatic Dynamic Noise
Reduction system. DNR%educes background hiss on AM and
FM
radio
broadcasts, as well as on cassette tapes. DNR@is a registered trademark of
National Semiconductor Corporation.
3-11
Seitenansicht 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare