Chevrolet Automobile Parts 2001 Bedienungsanleitung PDF herunterladen (Seite 9)

steering coupler pinch bolts and remove coupler from rack and pinion.

2) Raise and support vehicle. Remove front wheels. Disconnect

and separate front tie rod ends. See OUTER TIE ROD. Disconnect

electrical connectors. Remove stabilizer bar from crossmember.

Disconnect brake pipe from crossmember fastener clips. Remove rack and

pinion mounting bolts and nuts. Using hand tools only, LOOSEN, DO NOT

remove, four crossmember mounting nuts. Remove power rack and pinion

through left wheelwell opening by rotating.

Installation

To install, reverse removal procedure. Tighten nuts and bolts

to specification. See TORQUE SPECIFICATIONS. Fill and bleed hydraulic

system. See HYDRAULIC SYSTEM BLEEDING under lubrication. Adjust toe-in

as necessary. See appropriate SPECIFICATIONS & PROCEDURES article in

WHEEL ALIGNMENT.

Fig. 3: Mounting Bolt Tightening Sequence

Courtesy of General Motors Corp.

OVERHAUL

POWER STEERING PUMP (CB SERIES)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Keine Kommentare

Chevrolet Automobile Parts 2001 Bedienungsanleitung Seite 9