P/N: 4GR020-010 v1.7, 2009-11-25
©2009 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
8
Fig. 7-f
7. ALTERNATOR RELOCATION, cont’d
Fig. 7-g
dust shield onto the spring tensioner using
the supplied 25mm screw with a washer.
Install the spring tensioner onto the alternator
plate in the position shown in Fig. 7-g.
K. Tighten all of the screws.
L. Verify that the spring tensioner does not hit
the water pump when rotated down. If contact
occurs, remove the tensioner and sand addi-
tional material off of the back of it until there
is minimal clearance.
MODIFIED AREA
Kommentare zu diesen Handbüchern