Chevrolet 2004 Corvette Bedienerhandbuch PDF herunterladen (Seite 23)

P/N: 4GR020-010 v1.7, 2009-11-25

9. ABS MODULE RELOCATION

(1999-2000 Model vehicles only, all others

proceed with step 10.)

A. Attach the ABS module to the supplied brack-

et using two of the factory isolator mounts.

Attach the ABS module ground wire under

one of the nuts.

B. Install the supplied grommet into the supplied

ABS support strap.

C. Install the strap over the remaining pin on the

ABS module and bolt it to the ABS bracket

using the supplied hardware.

D. Use the factory hardware to install the

assembly in the original location. Some of the

holes are slotted, so before tightening, posi-

tion the ABS module so that the lowest brake

line connector exits immediately above the

steering rack. (See Fig. 9-a.)

E. The brake lines must now be carefully bent

by hand to connect out to their original loca-

tion on the ABS module. Bend each line and

loosely attach to the ABS module in the order

shown in Figs. 9-b.

F. With all of the lines loosely connected, estab-

lish the order in which to tighten them based

on the tools available. It may be necessary to

disconnect a couple of lines to provide

access to the hard to reach locations. (See

Fig. 9-d for recommended tools.)

G. Attach the ABS module plug and verify that

the wires are secured away from any moving

parts

NOTE: The following steps reposition the ABS module upside down

so that there will be room for the supercharger. It is very

important to spend as much time as necessary to ensure

that the brake lines are sound (not kinked or bent repeated-

ly), routed away from moving parts, and protected from abra-

sion wherever they touch non-moving parts or each other.

NOTE: When connecting the line to “MCI", the hard line

should be rotated where it connects to the braided

line to avoid twisting and damaging the braided line.

Carefully hold the crimp ferrule with pliers and rotate

the hard line by hand to the desired angle.

NOTE: A properly bent brake line will thread easily into the

ABS module. If a line does not thread in easily by

hand, it is not lined up properly. Do not force it.

STEP 5: BEND

AND LOOSELY

ATTACH “LF”

LINE

STEP 6: BEND AND

LOOSELY ATTACH

“RF” LINE. TIGHTEN

THE LINES INSTALLED

IN STEPS 3-6 IN

SEQUENCE

STEP 1: BEND THE

CORRECT LINE

FROM MASTER

CYLINDER SO THAT IT

CONNECTS EASILY TO

MC2 (TEMPORARILY

DISCONNECT)

STEP 2: BEND THE

CORRECT LINE FROM

MASTER CYLINDER

SO THAT IT CONNECTS

EASILY TO MC2

(TEMPORARILY

DISCONNECT)

STEP 4: BEND AND

LOOSELY ATTACH

“RR” LINE

STEP 3: BEND AND

LOOSELY ATTACH

“LR” LINE

STEP 7: ATTACH AND

TIGHTEN THE LINES FROM

THE MASTER CYLINDER

Fig. 9-a

Fig. 9-b

Fig. 9-c

Fig. 9-d

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2004 Corvette Bedienerhandbuch Seite 23

Kommentare zu diesen Handbüchern