Chevrolet 2004 Corvette Bedienerhandbuch PDF herunterladen (Seite 27)

P/N: 4GR020-010 v1.7, 2009-11-25

©2009 Vortech Engineering, LLC

All Rights Reserved, Intl. Copr. Secured

15

13. CHARGE AIR COOLER INSTALLATION, cont’d

RELAY

(+)BATTERY TERMINAL

(+)TERMINAL ON

WATER PUMP

GROUND

87

87A

86

85

30

TERMINAL #87 ON

FACTORY FUEL

PUMP RELAY

Fig. 13-e

Fig. 13-d

SUPPLIED RELAY

12. Connect the supplied long red wire to

the water pump power wire using a

female slide connector. Route the water

pump power wire up to and across the

cowl below the windshield and secure

using zip ties

B. Water pump wiring

1. Drill out the relay mounting hole to 1/4"

and mount the supplied relay using the

forward most screw on the passenger

side hood latch. (See Fig 13-d.)

2. Connect the water pump power wire up

to the relay terminal #87.

3. Using the supplied ring terminal connec-

tor, run the relay ground wire from termi-

nal #86 down to the ground terminal

located on top of the vehicle frame

below the battery.

4. Connect the supplied fuse holder from

the #30 relay terminal to the remote (+)

positive battery terminal on the fuse box

using a female slide connector and a

large ring terminal connector.

5. Using the yellow wire, connect relay ter-

minal #85 to the factory fuel pump relay

terminal #87 in the fuse box using the

supplied mini fuse tap and slide connec-

tor. (See Figs 13-e, 13-f, 13-g.)

C. Surge tank install

1. The surge tank will be installed just

behind the power steering reservoir on

the same bracket.

2. Connect a length of the supplied hose to

the 90° fitting installed in the bottom of

the supplied surge tank and point

towards the rear of the vehicle. Install

and tighten a plastic clamp.

3. Install another 90 degree fitting into the

surge tank opposite the two 1/4-20

mounting inserts. Point this fitting

towards the front of the vehicle. Attach

the supplied hose to this fitting with a

clamp.

4. Install the surge tank onto the bracket

using the supplied 1/4-20 screws. The

bracket may need to be loosened from

the head in order to install the surge

tank. (See Fig. 11-a.)

5. Route the hose attached to the bottom

of the surge tank to the 90° fitting

installed in the top of the reservoir.

Secure with a clamp.

6. Re-install the vehicle splash guard.

Fig. 13-f

Fig. 13-g

86

85

87

30

FACTORY

FUEL

PUMP

RELAY

FUSE TAP

MODIFICATION

BEND UP 90°

BEND UP 90°

FACTORY

FUEL

PUMP

RELAY

MODIFIED

FUSE TAP

INSTALLED MODIFIED

FUSE TAP

BOTTOM VIEW

SIDE VIEW

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare