Chevrolet 2004 Corvette Bedienerhandbuch PDF herunterladen (Seite 30)

P/N: 4GR020-010 v1.7, 2009-11-25

A. Install the supplied T-bolt clamp onto the alu-

minum supercharger inlet duct oriented so as

to be accessible after the supercharger is

installed. Slide the inlet duct onto the super-

charger so that the cast contour lines up with

the discharge section of the volute. (See Fig.

14-a.)

B. Install the 1/8 NPT x -4 x 90° fitting into the

supercharger oil feed nozzle. (See Fig.

14-b.)

C. Attach the oil drain hose to supercharger

using stepless clamp pliers and tighten the

clamp making sure that it is oriented so that it

will have maximum clearance to the power

steering pump pulley after the supercharger

is installed. (See Fig. 14-b.)

D. Install a 2-3/4" sleeve onto the supercharger

discharge. Loosely attach the discharge tube

to the charge air cooler. The end of the tube

with the 1" bung must be nearer to the

charge cooler when installed. (See Fig. 14-c.)

E. Install supercharger loosely with the oil drain

hose routed between the power steering pul-

ley and the frame rail. Start all four super-

charger mounting screws (3/8-16 x 1.75", 3/8-

16 x 3.00" and previously installed 2" screws)

and tighten.

F. Trim as necessary and attach the super-

charger oil drain hose to oil pan. Tighten hose

clamp.

G. Route oil feed hose to supercharger and

attach.

H. Secure both the oil drain, oil feed and power

steering hoses from moving components

(steering shaft) and high heat areas (exhaust

14. SUPERCHARGER INSTALLATION

NOTE: If inlet duct does not slide onto volute easily, verify

that there are no burrs on its inside diameter and

then heat up the duct to ease assembly.

Fig. 14-a

Fig. 14-c

NOTE: If the vehicle is equipped with ABS, verify that the

supercharger volute does not contact the module.

If contact will occur, sand the ABS module and/or

mounting bolt until there is minimal clearance.

NOTE: The oil drain hose MUST maintain a “downhill”

routing always. “Uphill" routing , Dips, kinks or

restrictions in the drain hose may cause super-

charger seal failure.

Fig. 14-b

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2004 Corvette Bedienerhandbuch Seite 30

Kommentare zu diesen Handbüchern