Chevrolet Equinox 2006 Bedienungsanleitung Seite 7

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 9
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 6
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If
you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a
qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all
instructions carefully.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please
consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to
take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance
requirements may apply to our motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that
your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
INSTALL INSTRUCTIONS: Blend Door Repair Kit
902-600
7
Figure 13 Passenger Side Enlarged Opening and Remaining End of Door Shaft
Figure 14 - Semi-transparent View of the HVAC Case with Views of Sleeve Alignment
23. Using an assistant to hold and align the temperature door from the driver’s side pivot point easy-out, align and install
the shaft sleeve to replace the passenger’s side of the shaft removed using the hole saw.
Note: To align shaft sleeve to temp door, hold the sleeve with the slot pointing toward the front of vehicle (3 o’clock
position) to find the proper alignment to the temperature door shaft. Reference Figure 14 to visualize the engagement of
the shaft sleeve onto the temp door shaft.
24. Align the air temperature actuator with the door shaft and rotate into position.
25. Install the air temperature actuator screws (Qty 3) to the HVAC module.
Tighten the screws to 1.5 N·m (13 lb in).
Seitenansicht 6
1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare