Chevrolet Equinox 2006 Bedienungsanleitung Seite 8

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 9
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 7
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If
you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a
qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all
instructions carefully.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please
consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to
take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance
requirements may apply to our motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that
your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
INSTALL INSTRUCTIONS: Blend Door Repair Kit
902-600
8
26. Connect the electrical connector to the air temperature actuator.
Note: Any time an actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to
ensure proper air distribution.
27. Connect the yellow airbag connector. Slide the yellow connector mount onto the HVAC module.
28. Remove the easy-out from driver’s side pivot point.
29. Calibrate the actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module three
times each, within two seconds of initial push.
The A/C and RECIRC button LED's will flash while this calibration is taking place.
The calibration will take anywhere between 10 to 30 seconds depending on battery voltage.
The LEDs will quit flashing when the calibration is complete.
30. Verify the repair by testing the temperature control while the temperature door shaft pivot point can still be seen from
the driver’s side footwell. Run the vehicle check for warm and cool air from the HVAC outlets.
31. Install the instrument panel compartment. Refer to Instrument Panel Compartment Replacement in your GM service
procedures manual.
32. Install the right sound insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side in your
GM service procedures manual.
33. Move the heater cover up into position. Install the heater cover screws (Qty 3).
Tighten the screws to 1.5 N·m (13 lb in.)
34. Install the communication interface module, if equipped. Refer to Communication Interface Module Replacement in
your GM service procedures manual.
35. Install the accelerator pedal assembly to the brake pedal bracket. Refer to Accelerator Pedal Position Sensor
Replacement in your GM service procedures manual.
36. Install the left side insulator/closeout panel. Refer to Instrumentation Panel Insulator Panel Replacement - Left Side
in your GM service procedures manual.
37. Install the driver knee bolster panel. Refer to Knee Bolster Replacement in your GM service procedures manual.
38. Install the center trim bezel as necessary.
Dorman Tech Line
800-868-5777
WWW.Dormanproducts.com
Seitenansicht 7
1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare