Chevrolet Window 6405/4410TK Bedienungsanleitung PDF herunterladen

POWER VISION

INSTALLATION INSTRUCTIONS

Models: 6405/4410 & 6405/4410TK GM/Chevrolet 2007 – current (new body style) full size trucks and

SUVs with manual power mirrors.

THIS SET IS DESIGNED FOR TRUCK WITH STOCK MANUAL MIRRORS. IF YOU

CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED.

Caution! - Do not attempt to manually extend or retract the mirrors. They should be moved under their own

motor power only.

Tools required for the installation are: 7mm and 10mm sockets, trim panel remover, philips screwdriver, small

screwdriver, needle nose pliers, razor knife, and an inch pound torque wrench. If you have any questions after

reading this installation manual, please call our service department at (800) 337-2557.

REMOVAL OF EXISTING MIRRORS

1. On the inside of the driver’s door, remove the triangular shaped trim piece and insulation foam in the

mirror mounting area.

2. Remove the door lock by using a small screwdriver to release the tab

while lifting the lock upward.

3. Remove door trim panel screws located under trim covers.

4. Remove window handle by releasing the retaining clip.

1 2 3 4 5

Seite 1

POWER VISION INSTALLATION INSTRUCTIONS Models: 6405/4410 & 6405/4410TK GM/Chevrolet 2007 – current (new body style) full size trucks and SU

Seite 2

6405/4410 Install PAGE 2 5. The door trim panels have a series of snaps around the outer edges. Unsnap the door trim panel. 6. Remove the door

Seite 3

6405/4410 Install PAGE 3 4. Insert the studs provided (3 for each side) with the tapered end out (see diagram E). They should screw into the mount

Seite 4

6405/4410 Install PAGE 4 4. Repeat steps 1 through 3 for the passenger side identifying the right side active turn signal wire (recommend trying da

Seite 5

6405/4410 Install Page 5 2. The next step is to run the main harness. Pop off both ends of the boot located between the door and cab. The main wiri

Keine Kommentare

Chevrolet Window 6405/4410TK Bedienungsanleitung