Chevrolet 2009 Suburban Bedienungsanleitung PDF herunterladen (Seite 434)

100

101

4. With the coolant surge tank pressure cap off, start

the engine and let it run until you can feel the upper

radiator hose getting hot. Watch out for the engine

cooling fan.

By this time, the coolant level inside the coolant

surge tank may be lower. If the level is lower, add

more of the proper mixture to the coolant surge tank

until the level reaches the FULL COLD mark.

5. Replace the pressure cap. Be sure the pressure

cap is hand-tight and fully seated.

6. Verify coolant level after engine is shut off and the

coolant is cold. If necessary, repeat coolant ﬁll

procedure Steps 1 through 6.

Notice: If the pressure cap is not tightly installed,

coolant loss and possible engine damage may occur.

Be sure the cap is properly and tightly secured.

Coolant Surge Tank Pressure Cap

If your vehicle is a Two-mode Hybrid, see the Two-mode

Hybrid manual for more information.

Notice: If the pressure cap is not tightly installed,

coolant loss and possible engine damage may occur.

Be sure the cap is properly and tightly secured.

The coolant surge tank pressure cap must be fully

installed on the coolant surge tank. See Engine

Compartment Overview on page 5-14 for more

information on location.

5-34

1 2 ... 429 430 431 432 433 434 435 436 437 438 439 ... 577 578

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2009 Suburban Bedienungsanleitung Seite 434

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chevrolet 2009 Suburban