Chevrolet 2011 Suburban Bedienungsanleitung PDF herunterladen (Seite 387)

Black plate (13,1)

Chevrolet Tahoe/Suburban Owner Manual - 2011

Vehicle Care 10-13

6. Using the TRANS TEMP

reading, determine and perform

the appropriate check

procedure. If the TRANS TEMP

reading is not within the required

temperature ranges, allow the

vehicle to cool, or operate the

vehicle until the appropriate

transmission fluid temperature is

reached.

Cold Check Procedure

Use this procedure only as a

reference to determine if the

transmission has enough fluid to be

operated safely until a hot check

procedure can be made. The hot

check procedure is the most

accurate method to check the fluid

level. Perform the hot check

procedure at the first opportunity.

Use this cold check procedure to

check fluid level when the

transmission temperature is

between 27°C and 32°C

(80°F and 90°F).

1. Locate the transmission dipstick

at the rear of the engine

compartment, on the passenger

side of the vehicle.

See Engine Compartment

Overview on page 10‑6 for more

information.

2. Flip the handle up, then pull out

the dipstick and wipe it with a

clean rag or paper towel.

3. Install the dipstick by pushing it

back in all the way; wait

three seconds, and then pull it

back out again.

4. Check both sides of the dipstick

and read the lower level. Repeat

the check procedure to verify the

reading.

5. If the fluid level is below the

COLD check band, add only

enough fluid as necessary to

bring the level into the COLD

band. It does not take much

fluid, generally less than 0.5 L

(1 pt). Do not overfill.

6. Perform a hot check at the

first opportunity after the

transmission reaches a normal

operating temperature between

71°C to 93°C (160°F to 200°F).

7. If the fluid level is in the

acceptable range, push the

dipstick back in all the way, then

flip the handle down to lock the

dipstick in place.

1 2 ... 382 383 384 385 386 387 388 389 390 391 392 ... 521 522

Kommentare zu diesen Handbüchern

Keine Kommentare