Chevrolet 2001 Corvette Bedienungshandbuch PDF herunterladen (Seite 152)

2-90

Emissions Inspection and Maintenance Programs

Some state/provincial and local governments have or

may begin programs to inspect the emission control

equipment on your vehicle. Failure to pass this

inspection could prevent you from getting a

vehicle registration.

Here are some things you need to know in order to help

your vehicle pass an inspection:

Your vehicle will not pass this inspection if the

CHECK ENGINE light is on or not working properly.

Your vehicle will not pass this inspection if the

OBD (on

-board diagnostic) system determines that

critical emission control systems have not been

completely diagnosed by the system. The vehicle would

be considered not ready for inspection. This can happen

if you have recently replaced your battery or if your

battery has run down. The diagnostic system is designed

to evaluate critical emission control systems during

normal driving. This may take several days of routine

driving. If you have done this and your vehicle still does

not pass the inspection for lack of OBD system

readiness, see your dealer or qualified service center to

prepare the vehicle for inspection.

Engine Oil Pressure Gage

United States Canada

The engine oil pressure gage shows the engine oil

pressure in psi (pounds per square inch) or

kPa (kilopascals) when the engine is running.

Oil pressure should be 20 to 80 psi (140 to 550 kPa).

In certain situations such as long, extended idles on hot

days, it could read as low as 6 psi (40 kPa) and still be

considered normal. It may vary with engine speed,

outside temperature and oil viscosity, but readings above

the shaded area show the normal operating range.

Readings in the shaded area tell you that the engine is

low on oil, or that you might have some other oil

problem. See “Engine Oil” in the Index.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 382 383

Keine Kommentare

Chevrolet 2001 Corvette Bedienungshandbuch Seite 152