Chevrolet 2003 Impala Bedienungsanleitung Seite 8

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 10
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 7
INSTALL/REMOVAL INSTRUCTIONS: WINDOW LIFT MOTOR
742-125
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
8
©2013 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 5: Temporarily connect the power switch assembly to raise or lower the window
regulator, aligning the points mounting the door glass to the window regulator.
STEP 6: Manually slide the door glass into position, aligning the points attaching the door
glass to the window regulator.
STEP 6a: Using a 10mm socket and ratchet assembly, attach the door glass to the window
regulator. NOTE: If you did not remove the Styrofoam noise insulator please go to Step 8.
STEP 7: Install the Styrofoam noise insulator.
STEP 3: Using a 10mm socket and ratchet
assembly, attach the three (3) window lift
motor attaching screws.
STEP 4: Connect the window lift
motor connector.
Seitenansicht 7
1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare