Chevrolet 2005 Corvette Spezifikationen PDF herunterladen (Seite 101)

Be sure that people and objects are clear of the garage

door or gate operator you are programming. When

programming a garage door, it is advised to park outside

of the garage.

It is recommended that a new battery be installed in

your hand-held transmitter for quicker and more

accurate transmission of the radio frequency.

Programming HomeLink

Your vehicle’s engine should be turned off while

programming the transmitter. Follow these steps to

program up to three channels:

1. Press and hold down the two outside buttons,

releasing only when the indicator light begins to

ﬂash, after 20 seconds. Do not hold down the

buttons for longer than 30 seconds and do not

repeat this step to program a second and/or third

transmitter to the remaining two HomeLink

buttons.

2. Position the end of your hand-held transmitter about

1 to 3 inches (3 to 8 cm) away from the HomeLink

buttons while keeping the indicator light in view.

3. Simultaneously press and hold both the desired

button on HomeLink

and the hand-held transmitter

button. Do not release the buttons until Step 4

has been completed.

Some entry gates and garage door openers may

require you to substitute Step 3 with the procedure

noted in “Gate Operator and Canadian

Programming” later in this section.

4. The indicator light will ﬂash slowly at ﬁrst and then

rapidly after HomeLink

successfully receives the

frequency signal from the hand-held transmitter.

Release both buttons.

5. Press and hold the newly-trained HomeLink

button

and observe the indicator light.

If the indicator light stays on constantly,

programming is complete and your device should

activate when the HomeLink

button is pressed

and released.

To program the remaining two HomeLink

buttons,

begin with Step 2 under “Programming HomeLink

.”

Do not repeat Step 1 as this will erase all of the

programmed channels.

If the indicator light blinks rapidly for two seconds

and then turns to a constant light, continue with

Steps 6 through 8 following to complete the

programming of a rolling-code equipped device

(most commonly, a garage door opener).

6. Locate in the garage, the garage door opener

receiver (motor-head unit). Locate the “Learn”

or “Smart” button. This can usually be found where

the hanging antenna wire is attached to the

motor-head unit.

2-43

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 395 396

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2005 Corvette Spezifikationen Seite 101

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chevrolet 2005 Corvette