Chevrolet 2011 Tahoe Wartungshandbuch PDF herunterladen (Seite 68)

Black plate (20,1)

Chevrolet Tahoe and GMC Yukon/Yukon Denali Hybrid - 2011

10-20 Vehicle Care

.

One or more TPMS sensors are

missing or damaged. The DIC

message and the TPMS

malfunction light should go off

when the TPMS sensors are

installed and the sensor

matching process is performed

successfully. See your dealer for

service.

.

Replacement tires or wheels do

not match your vehicle's original

equipment tires or wheels. Tires

and wheels other than those

recommended for your vehicle

could prevent the TPMS from

functioning properly. See

“Buying New Tires” in the owner

manual.

.

Operating electronic devices or

being near facilities using radio

wave frequencies similar to the

TPMS could cause the TPMS

sensors to malfunction.

If the TPMS is not functioning it

cannot detect or signal a low tire

condition. See your dealer for

service if the TPMS malfunction

light and DIC message comes on

and stays on.

TPMS Sensor Matching

Process

Each TPMS sensor has a unique

identification code. Any time you

rotate your vehicle's tires or replace

one or more of the TPMS sensors,

the identification codes will need to

be matched to the new tire/wheel

position. The sensors are matched

to the tire/wheel positions in the

following order: driver side front tire,

passenger side front tire, passenger

side rear tire, and driver side rear

tire using a TPMS diagnostic tool.

See your dealer for service.

The TPMS sensors can also be

matched to each tire/wheel position

by increasing or decreasing the

tire's air pressure. If increasing the

tire's air pressure, do not exceed

the maximum inflation pressure

indicated on the tire's sidewall.

To decrease air-pressure out of a

tire you can use the pointed end of

the valve cap, a pencil-style air

pressure gauge, or a key.

You have two minutes to match

the first tire/wheel position, and

five minutes overall to match all four

tire/wheel positions. If it takes longer

than two minutes, to match the first

tire and wheel, or more than

five minutes to match all four tire

and wheel positions the matching

process stops and you need to

start over.

The TPMS sensor matching process

is outlined below:

1. Set the parking brake.

2. Turn the ignition switch to ON/

RUN with the engine off.

3. Press

Q and K on the Remote

Keyless Entry (RKE) transmitter

at the same time for

approximately five seconds. The

horn sounds twice to signal the

receiver is in relearn mode and

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 97 98

Kommentare zu diesen Handbüchern

Keine Kommentare