Chevrolet Air Conditioner Camaro Bedienungsanleitung PDF herunterladen (Seite 15)

2) Raise and support vehicle. Remove compressor and condenser

hose assembly fitting at condenser. Discard "O" ring. Lower vehicle.

Remove accumulator tube. Remove radiator air upper baffle from

condenser. Remove condenser.

3) To install, reverse removal procedure. Lightly coat "O"

rings with mineral-base refrigerant oil. Evacuate and charge A/C

system.

EVAPORATOR TUBE

Removal

Disconnect negative battery cable. Discharge A/C system,

using approved refrigerant recovery/recycling equipment. Disconnect

electrical connector at refrigerant pressure sensor. Remove strap from

evaporator tube. Remove accumulator tube. See ACCUMULATOR. Remove

evaporator tube fitting at accumulator and condenser. Remove

evaporator tube and discard "O" rings.

Installation

To install, reverse removal procedure. Clean all fittings

with mineral-base refrigerant oil. Lightly coat all seals with

mineral-base refrigerant oil before assembling. Evacuate and charge

A/C system.

EVAPORATOR

Removal

1) Disconnect negative battery cable. Discharge A/C system,

using approved refrigerant recovery/recycling equipment. Remove right

instrument panel sound insulator panel. Drain cooling system. Remove

heater hoses at heater core. Open glove box. Push sides of glove box

and remove glove box. Remove heater core. See HEATER CORE.

2) Remove temperature control cable at A/C-heater case.

Remove bolts, located in engine compartment, from A/C-heater case.

Slide A/C-heater case down to disengage upper case clip and A/C-heater

case.

3) Place a mat on passenger side floor to protect carpeting.

Using a small hand saw, remove perforated section of A/C-heater case

as one piece (DO NOT discard). Remove bolts and hoses retaining A/C

evaporator. Slide evaporator to left. Remove evaporator from A/C-

heater case. See Fig. 3.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Chevrolet Air Conditioner Camaro Bedienungsanleitung Seite 15