Chevrolet Impala 2007 Impala Wartungshandbuch PDF herunterladen (Seite 75)

WIRING

WIRING Impala

Approximately 65 inches (165 cm) of auxiliary speaker wire is run from

the instrument panel radio connector and is coiled under the center of

the instrument panel. The wiring permits the connection of front door

speakers to customer-installed communication equipment.

Radio outputs from the front speakers are sent to the rear speakers to

maintain the required open door/key in the ignition reminder chime.

Electrical Connections

1. Disconnect the negative (–) battery cable at the battery.

2. Remove the tape from the wire coiled under the instrument panel to

uncoil it.

3. Using proper electrical connectors, connect the wires for the left

front audio output of the customer-installed communication device.

The left front positive wire is tan and the left front negative wire is

gray.

4. Using proper electrical connectors, connect the wires for the right

front audio output of the customer-installed communication device.

The right front positive wire is light green and the right front

negative wire is dark green. The electrical impedance of each

speaker installed is 10 ohms.

NOTICE: OVERLOADING THE VEHICLE’S ELECTRICAL SYSTEM MAY

DAMAGE YOUR VEHICLE’S ACCESSORIES. DO NOT OVERLOAD THE

VEHICLE’S SYSTEM BY HAVING UNNECESSARY ACCESSORIES ON AT

THE SAME TIME.

5. The ignition must be turned off and the vehicle must be vacated

prior to attaching the cable to the battery. Connect the negative (–)

battery cable to the battery and tighten the bolt to 11 lb ft (15 N·m).

6. Set the time on the clock and radio pushbuttons as needed. See

“Audio Systems” in the Instrument Panel section of your Impala

owner’s manual for more information.

WIRING PROVISIONS FRONT SPEAKERS – SEO WX7

WIRING DIAGRAM FOR SEO WX7 INLINE CONNECTOR

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

Keine Kommentare

Chevrolet Impala 2007 Impala Wartungshandbuch Seite 75