CAMARO Z/28
TRACK PREPARATION
5. DOMINATE THE TRACK
Camaro Z/28 is equipped with Performance Traction Management (PTM), which integrates the Traction Control, StabiliTrak®
and Selective Ride Control systems to provide improved and consistent performance when cornering on a track. The amount of
available engine power is based on the mode selected, track conditions, driver skill and the radius of each corner.
PERFORMANCE TRACTION MANAGEMENT (OWNER’S MANUAL: 9-42)
PTM can be selected by quickly pressing the TCS/StabiliTrak® button on the console two times. The appropriate message displays
in the DIC. To experience the performance benefit of this system, after entering a curve and at the point where the driver would
normally start to increase acceleration, the accelerator pedal can be fully pressed. The PTM system will modify the level of engine
power for a smooth and consistent corner exit. The PTM system contains five modes. To select a mode while in PTM:
•
Press the Selective Ride Control/PTM −TOUR or +SPORT button on the center console
•
Scroll up or down through modes 1–5 by pressing the −TOUR or +SPORT button
Five PTM performance levels are available:
•
Mode 1 – Traction Control set for wet or damp conditions, with Stability Control on. Steering efforts set to Tour
•
Mode 2 – Intended for entry-level drivers. Traction Control set for dry conditions with Stability Control on. Steering set to Tour
•
Mode 3 – Intended for an entry-level driver that has become familiar with the track. Traction Control set on Sport, Stability
Control set to Mode 2. Steering effort set to Sport
•
Mode 4 – Intended for intermediate level drivers familiar with the track. Traction Control set on Sport, Stability Control off.
Steering efforts set to Sport
•
Mode 5 – Intended for expert level driver familiar with the track. Traction Control set on Race, with Stability Control off.
Steering efforts set to Track
AFTER THE TRACK
•
Return the tire pressure settings to factory (see the Tire and Loading Information label located below the door latch with
the door open)
•
Return the wheel alignment settings to factory
•
Replace oil
•
Replace brake fluid
•
Replace rear axle fluid
•
Replace the coolant/water mix to factory setting and replace the water deflector on the engine side of the hood scoop
(if removed)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern