Page 2
1/2" MIN. CLEARANCE
Mounting
Strap
Mounting
Foot
(Bottom View)
Tension Bolt
Tinnerman
Nut
Roof Surface
Gutter
Mounting
Foot
Fig. 1
Weatherstrip
Fig. 2
Screw
The installation of this unit will
require drilling. It is absolutely
necessary to make sure that no
components could be damaged in
the process. If damage is possible,
select a different mounting location.
CAUTION!
62929
LIGH
TBARS
W
H
E
LE
N
BY
Tinnerman
Nut
Actuator
Mounting
Strap
Mounting Foot
Assembly
(2) 10 X 1/2“
PPHSMS
15/16 - 18 X 3“
Tension Bolt
INSTALLATION:
1. Position the lightbar in the desired location. Refer to your
lightbar manual for the cable exit location, to be sure that the
lightbar is facing the proper direction.
2. With the location determined, adjust the two mounting feet
outwards so that they are resting on the surface outside the
roof’s gutter (See Fig. 1). To adjust the mounting feet, loosen the
two 3/8” bolts that secure the feet to the extrusion. Make sure
that both mounting feet are in full contact with the roof and not
hanging off the edge. Also confirm that there is at least 1/2”
clearance between the bottom of the lightbar and the roof of the
vehicle. When properly positioned, retighten these bolts to hold
the foot in place. Repeat this procedure for the remaining foot.
3. Open the driver’s side door. In the area directly below the
mounting foot, carefully
separate the weatherstripping from the
vehicle using a razor blade or similar tool. Only separate enough
weatherstriping to accommodate the mounting strap. Repeat
this procedure for the passenger’s side of the vehicle.
4. Insert the mounting strap through the mounting foot as shown in
Fig 3. Be sure that the strap fits flush against the mounting area
where it will be secured onto the vehicle. Insert the tension bolt
through the mounting strap and into the tinnerman nut on the
actuator plate. Tighten slightly with a long-shafted, Phillips
screwdriver. Repeat procedure for the passenger’s side.
5. Use the holes in the gutter end of the strap as a template to drill
two appropriately sized pilot holes through the strap and into the
vehicle. Repeat this for passenger’s side of the vehicle.
6. Insert the supplied mounting screws into these holes and tighten
firmly. Repeat for passenger’s side of the vehicle.
7. Now firmly tighten the tension bolt to secure the lightbar to
the vehicle.
8. Reposition and adhere the loose
weatherstriping to the mounting strap using
RTV.
Fig. 3
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern