Chevrolet 2006 Avalanche Spezifikationen PDF herunterladen (Seite 237)

4. Press the trip/fuel button until the vehicle heading, for

example, N for North, is displayed in the DIC. Or, if

the vehicle does not have DIC buttons, press and

hold the trip odometer reset stem for two seconds to

select the next available variance zone. Repeat this

step until the appropriate variance zone is displayed.

5. If calibration is necessary, calibrate the compass.

See “Compass Calibration Procedure” following.

Compass Calibration

The compass can be manually calibrated. Only calibrate

the compass in a magnetically clean and safe location,

such as an open parking lot, where driving the vehicle in

circles is not a danger. It is suggested to calibrate

away from tall buildings, utility wires, manhole covers, or

other industrial structures, if possible.

If CAL should ever appear in the DIC display, the

compass should be calibrated.

If the DIC display does not show a heading, for example,

N for North, or the heading does not change after

making turns, there may be a strong magnetic ﬁeld

interfering with the compass. Such interference may be

caused by a magnetic CB or cell phone antenna

mount, a magnetic emergency light, magnetic note pad

holder, or any other magnetic item. Turn off the

vehicle, move the magnetic item, then turn on the

vehicle and calibrate the compass.

To calibrate the compass, use the following procedure:

Compass Calibration Procedure

1. Before calibrating the compass, make sure the

compass zone is set to the variance zone in

which the vehicle is located. See “Compass

Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window,

sunroof, climate controls, seats, etc. during

the calibration procedure.

2. Press the vehicle information button until

PRESS

V TO CALIBRATE COMPAS (Compass)

displays. Or, if the vehicle does not have DIC

buttons, press the trip odometer reset stem until

CALIBRATE COMPASS displays.

3. Press the set/reset button to start the compass

calibration. Or, if the vehicle does not have DIC

buttons, press and hold the trip odometer reset stem

for two seconds to start the compass calibration.

4. The DIC will display CALIBRATING: DRIVE IN

CIRCLES. Drive the vehicle in tight circles at less

than 5 mph (8 km/h) to complete the calibration. The

DIC will display CALIBRATION COMPLETE for a

few seconds when the calibration is complete. The

DIC display will then return to the previous menu.

3-57

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 549 550

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2006 Avalanche Spezifikationen Seite 237

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto-Videosysteme Chevrolet 2006 Avalanche