Chevrolet 2002 Impala Bedienungshandbuch PDF herunterladen (Seite 115)

2-49

Flash-to-Pass Feature

With the turn signal lever in the low-beam position, pull

the lever toward you momentarily to switch to

high

-beams (to signal that you are going to pass).

If you have the headlamps on, they will return to

low

-beams when you release the lever.

This feature operates even when the headlamps are off.

Windshield Wipers

The windshield wipers will operate with the ignition in

ACC or ON.

WIPER: To operate the windshield wipers, turn the

band labeled WIPER, located on the multifunction lever,

upward or downward.

OFF: To stop the wipers turn the band to OFF.

The five marks between OFF and LO are delay settings.

For a longer delay between wiping cycles, turn the band

downward. For a shorter delay between wiping cycles

turn the band upward.

LO (Low Speed): Turn the band up to LO for a steady

wiping at a low speed.

HI (High Speed): Turn the band up to HI for a steady

wiping at a high speed.

MIST: Turn the band downward to MIST for a single

wiping cycle. Hold the band at this setting until the

windshield wipers start, then release it. The windshield

wipers will stop after one wipe. If additional cycles are

needed, hold the band on MIST longer.

Be sure to clear ice and snow from the wiper blades

before using them. Hold the band at this setting until the

windshield wipers start, then release it. The windshield

wipers will stop after one wipe. If additional cycles are

needed, hold the band on MIST longer.

Heavy snow or ice can overload your wipers. A circuit

breaker will stop them until the motor cools. Clear away

snow or ice to prevent an overload. If your blades

become damaged, get new blades or blade inserts.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 396 397

Keine Kommentare

Chevrolet 2002 Impala Bedienungshandbuch Seite 115