Chevrolet 2003 Malibu Spezifikationen Seite 141

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 354
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 140
Audio
System(s)
Notice:
Before you add any sound equipment to
your vehicle
-
like a tape player, CB radio, mobile
telephone or two-way radio
-
be sure you can
add what you want.
If
you can, it’s very important
to do it properly. Added sound equipment may
interfere with the operation
of
your vehicle’s engine,
Delphi Electronics radio or other systems, and
even damage them. Your vehicle’s systems may
interfere with the operation of sound equipment that
has been added improperly.
So,
before adding sound equipment, check with
your dealer and be sure to check federal rules
covering mobile radio and telephone units.
Your audio system has been designed to operate easily
and
to
give years of listening pleasure. You will get the
most enjoyment out of it
if
you acquaint yourself with it
first. Find out what your audio system can do and how
to
operate all of its controls to be sure you’re getting the
most out of the advanced engineering that went into
it.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, you can play your audio
system even after the ignition is turned
off.
See Retained
Accessory Power under
Ignition Positions on page
2-18.
Setting the
Radio Data
Time
for
Radios without
Systems (RDS)
Press and hold the HR or MIN arrow for two seconds.
Then press the HR arrow until the correct hour appears
on the display. Press and hold the MIN arrow until
the correct minute appears. The time may be set with
the ignition on or
off.
Setting the Time
for
Radios with
Radio Data Systems (RDS)
Press and hold the HR or MN buttons, located below
the tune knob, for two seconds. Then press and hold HR
until the correct hour appears on the display. AM or
PM will also appear. Press and hold MN until the correct
minute appears on the display. The time may be set
with the ignition on or
off.
The clock symbol will appear
on the display in time-set mode.
To
synchronize the time with an FM station broadcasting
Radio Data System
(RDS)
information, press and hold
HR and MN at the same time for two seconds until
UPDATED and the clock symbol appear on the display.
If
the time is not available from the station, NO UPDAT
will appear on the display instead.
RDS time is broadcast once a minute. Once you have
tuned
to
an RDS broadcast station, it may take a
few minutes before pressing and holding the HR and
MN
buttons
to
result in an update to the time.
3-38
Seitenansicht 140
1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 353 354

Kommentare zu diesen Handbüchern

Keine Kommentare