Chevrolet 2004 Corvette Spezifikationen PDF herunterladen (Seite 138)

Automatic Operation

AUTO (Automatic): Press the AUTO button to place

the entire system in the automatic mode. When

automatic operation is active, the system will

automatically control the inside temperature, the air

delivery mode and the fan speed.

After a ﬁve-second display of the current settings, only

the word AUTO and the outside temperature will be

shown on the digital display unless the system is set to

full cold 60°F (16°C) or full hot 90°F (32°C), then the

word AUTO will not display. The system will operate to

achieve your comfort set temperature as quickly as

possible. The AUTO control system works best with the

windows up and the removable roof installed or the

convertible top up.

1. Press the AUTO button.

2. Adjust the temperature to a comfortable setting

between 60°F (16°C) or full hot 90°F (32°C).

Choosing the coldest or warmest temperature

setting will not cause the system to heat or cool

any faster. If you set the system at the coldest or

warmest temperature setting, the system will remain

in manual mode at that temperature and it will not

go into automatic mode.

In cold weather, the system will start at reduced fan

speeds at avoid blowing cold air into your vehicle

until warmer air is available. The system will start out

blowing air at the ﬂoor but may change modes

automatically as the vehicle warms up to maintain the

chosen temperature setting. The length of time

needed for warm up will depend on the outside

temperature and the length of time that has elapsed

since your vehicle was last driven.

3. Wait for the system to regulate. This may take from

10 to 30 minutes. Then adjust the temperature,

if necessary.

Do not cover the solar sensor located in the center of

the instrument panel, near the windshield. For more

information on the solar sensor, see “Sensor” later in

this section.

3-24

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 383 384

Keine Kommentare

Chevrolet 2004 Corvette Spezifikationen Seite 138