Chevrolet 2007 Yukon XL Denali Spezifikationen PDF herunterladen (Seite 476)

To adjust the vertical aim, do the following:

1. Open the hood. See Hood Release on

page 435 for more information.

2. Locate the aim dot on the lens of the

low-beam headlamp.

3. Measure the distance from the ground to the

aim dot on the low-beam headlamp. Record

the distance.

4. At the wall or other ﬂat surface, measure from

the ground upward (A) to the recorded

distance from Step 3 and mark it.

5. Draw or tape a horizontal line (B) on the wall

or ﬂat surface the width of the vehicle at the

height of the mark in Step 4.

Notice: Do not cover a headlamp to improve

beam cut-off when aiming. Covering a

headlamp may cause excessive heat build-up

which may cause damage to the headlamp.

6. Turn on the low-beam headlamps and place a

piece of cardboard or equivalent in front of the

headlamp not being adjusted. This allows

only the beam of light from the headlamp

being adjusted to be seen on the ﬂat surface.

476

1 2 ... 471 472 473 474 475 476 477 478 479 480 481 ... 607 608

Kommentare zu diesen Handbüchern

Keine Kommentare