Chevrolet 2010 Avalanche Bedienungsanleitung PDF herunterladen (Seite 359)

Black plate (15,1)

Chevrolet Avalanche Owner Manual - 2012

Vehicle Care 10-15

Hot Check Procedure

Use this procedure to check the

transmission fluid level when the

transmission fluid temperature is

between 71°C and 93°C (160°F

and 200°F).

The hot check is the most accurate

method to check the fluid level. The

hot check should be performed at

the first opportunity in order to verify

the cold check. The fluid level rises

as fluid temperature increases,

so it is important to ensure the

transmission temperature is within

range.

1. Locate the transmission dipstick

at the rear of the engine

compartment, on the passenger

side of the vehicle.

See Engine Compartment

Overview on page 10‑6 for more

information.

2. Flip the handle up and then pull

out the dipstick and wipe it with

a clean rag or paper towel.

3. Install the dipstick by pushing

it back in all the way, wait

three seconds, and then pull it

back out again.

4. Check both sides of the dipstick

and read the lower level. Repeat

the check procedure to verify the

reading.

5. Safe operating level is within the

HOT cross hatch band on the

dipstick. If the fluid level is not

within the HOT band, and the

transmission temperature is

between 71°C and 93°C (160°F

and 200°F), add or drain fluid as

necessary to bring the level into

the HOT band. If the fluid level is

low, add only enough fluid to

bring the level into the HOT

band. It does not take much

fluid, generally less than 0.5 L

(1 pt ). Do not overfill.

6. If the fluid level is in the

acceptable range, push the

dipstick back in all the way, then

flip the handle down to lock the

dipstick in place.

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 507 508

Kommentare zu diesen Handbüchern

Keine Kommentare