8.
Grasp the bottom
of
the cover and slide it rearward.
Then, lift it up and out
of
the vehicle.
Installing the Engine Cover
1.
Lift the engine cover into the vehicle and slide it all
the way forward. Make sure the rubber seal
is
over
the latches.
2.
Install the two bolts at the engine cover.
3.
Put the heater duct over the engine cover studs. Push
up
on
the duct gently until it snaps into place.
4.
Reconnect the electrical connectors.
5.
Install the engine cover extension by gently
squeezing the sides and sliding it into place.
Make sure all of the fastener clips engage and the
extension fits properly in place. Replace and tighten
the
two screws.
6.
Install
the
two nuts
to
secure
the
extension in place.
6-18
Kommentare zu diesen Handbüchern