Chevrolet 1998 Corvette Bedienungshandbuch Seite 64

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 378
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 63
Resynchronizing Your Transmitter
Your
RFA
system uses a continually changing code for
increased security. Normally, the receiver in your
vehicle will keep track of this changing code.
,If
your
vehicle does not respond to your transmitter, do the
following to determine what’s wrong:
1.
Get closer to the vehicle and try pressing a button
again. Your battery may be low (If
so,
see “Battery
Replacement” in the Index).
2.
While standing close to your vehicle, press the
LOCK and UNLOCK buttons on your transmitter at
the same time and hold
for
seven seconds. This will
attempt to resynchronize
the
security code in your
RFA
key fob transmitter.
3.
When resynchronization is achieved, the horn
will chirp.
Loss
of synchronization will occur after transmitter
battery replacement or disconnection of the
vehicle’s battery.
If
attempts to resynchronize your transmitter to the
vehicle are not successful, you may need
to
match the
transmitter to the vehicle.
Matching Transmitter(s) To Your Vehicle
Each key fob transmitter is coded to prevent another
transmitter from unlocking your vehicle.
If
a transmitter
is lost or stolen,
a
replacement can be purchased through
your dealer. Remember to bring any remaining
transmitters with you when you go to your dealer. When
the dealer matches the replacement transmitter to your
vehicle, any remaining transmitters must also be
matched. Once your dealer has coded the new
transmitter, the lost transmitter will not unlock your
vehicle. Each vehicle can have only three transmitters
matched to it.
To
match transmitters to your vehicle:
1.
Turn the ignition key to the
ON
position.
2.
Clear any warning messages on the Driver
Information Center (DIC) by pressing the
RESET button.
3.
Press the OPTIONS button on the DIC several times
until the blank page is displayed, then press and hold
the RESET button for two seconds.
2-11
Seitenansicht 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 377 378

Kommentare zu diesen Handbüchern

Keine Kommentare