Chevrolet 2000 Blazer Bedienungshandbuch Seite 332

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 430
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 331
6-38
Two-Piece Front Turn Signal
Lamp Assembly
1. Remove the headlamp assembly as shown under
“Two
-Piece Composite Headlamp System” earlier in
this section.
2. Locate the locking
tabs on the assembly.
Squeeze the tabs
together and push that
end of the assembly out
while holding the tabs.
The assembly will
swing out.
3. Unplug the electrical connector.
4. Turn the harness bulb socket counterclockwise to
remove it.
5. Pull the bulb straight out to remove it from the socket.
6. Push the new bulb into the socket until it snaps
into place.
7. Put the new bulb into the headlamp assembly and
turn it clockwise until it is tight.
8. To replace the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
9. Install the two retaining clips.
Seitenansicht 331
1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 429 430

Kommentare zu diesen Handbüchern

Keine Kommentare