Chevrolet 2007 Monte Carlo Bedienungshandbuch PDF herunterladen (Seite 104)

2-38

Turn Signal and Lane Change Indicator

The turn signal has two upward (for right) and two

downward (for left) positions. These positions allow you

to signal a turn or a lane change.

To signal a turn, move the lever all the way up or

down. When the turn is finished, the lever will

return automatically.

A green arrow on the

instrument panel cluster will

flash in the direction of the

turn or lane change.

To signal a lane change, just raise or lower the lever

until the arrow starts to flash. Hold it there until you

complete your lane change. The lever will return by

itself when you release it.

If the arrow flashes faster than normal as you signal a

turn or a lane change, a signal bulb may be burned out

and other drivers won’t see your turn signal.

If a bulb is burned out, replace it to help avoid an

accident. If the arrows don’t go on at all when you

signal a turn, check for burned

-out bulbs and then check

the fuse (see “Fuses and Circuit Breakers” in the Index).

Turn Signal On Chime

If you leave either one of your turn signals on and drive

more than 3/4 mile (1.2 km), a chime will sound to

alert you.

Headlamp High/Low Beam Changer

To change your headlamps

from low beams to high

beams, or high to low, pull

the multifunction lever all

the way toward you. Then

release it.

When the high beams are on, this blue light on the

instrument panel cluster also will be on. This light

works only when the ignition key is in the ON position.

Also, your fog lamps (if equipped) will not illuminate

when your high beams are on.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 369 370

Keine Kommentare

Chevrolet 2007 Monte Carlo Bedienungshandbuch Seite 104