Chevrolet 2007 Monte Carlo Bedienungshandbuch PDF herunterladen (Seite 90)

2-24

Starting Your 3800 Series II V6 Engine

1. Without pushing the accelerator pedal, turn your

ignition key to START. When the engine starts, let

go of the key. The idle speed will go down as your

engine gets warm.

NOTICE:

Holding your key in START for longer than

15 seconds at a time will cause your battery to be

drained much sooner. And the excessive heat can

damage your starter motor. Wait about

15 seconds between each try to help avoid

draining your battery or damaging your starter.

2. If it doesn’t start right away, hold your key in

START for about three to five seconds at a time until

your engine starts. Wait about 15 seconds between

each try to help avoid draining your battery or

damaging your starter.

3. If your engine still won’t start (or starts but then stops),

it could be flooded with too much gasoline. Try

pushing your accelerator pedal all the way to the floor

and holding it there as you hold the key in START for

about three seconds. If the vehicle starts briefly but

then stops again, do the same thing, but this time keep

the pedal down for five or six seconds. This clears the

extra gasoline from the engine. After waiting about

15 seconds, repeat the normal starting procedure.

NOTICE:

Your engine is designed to work with the

electronics in your vehicle. If you add electrical

parts or accessories, you could change the way

the engine operates. Before adding electrical

equipment, check with your dealer. If you don’t,

your engine might not perform properly.

If you ever have to have your vehicle towed, see

the part of this manual that tells how to do it

without damaging your vehicle. See “Towing

Your Vehicle” in the Index.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 369 370

Keine Kommentare

Chevrolet 2007 Monte Carlo Bedienungshandbuch Seite 90