Chevrolet 2010 Tahoe Spezifikationen PDF herunterladen (Seite 88)

TPMS Sensor Matching Process

Each TPMS sensor has a unique identification code.

Any time you rotate your vehicle's tires or replace one

or more of the TPMS sensors, the identification codes

will need to be matched to the new tire/wheel position.

The sensors are matched to the tire/wheel positions in

the following order: driver side front tire, passenger

side front tire, passenger side rear tire, and driver side

rear tire using a TPMS diagnostic tool. See your

dealer/retailer for service.

The TPMS sensors can also be matched to each

tire/wheel position by increasing or decreasing the

tire's air pressure. If increasing the tire's air pressure,

do not exceed the maximum inflation pressure indicated

on the tire's sidewall.

To decrease air-pressure out of a tire you can use the

pointed end of the valve cap, a pencil-style air pressure

gage, or a key.

You have two minutes to match the first tire/wheel

position, and five minutes overall to match all four

tire/wheel positions. If it takes longer than two minutes,

to match the first tire and wheel, or more than

five minutes to match all four tire and wheel positions

the matching process stops and you need to start over.

The TPMS sensor matching process is outlined below:

1. Set the parking brake.

2. Turn the ignition switch to ON/RUN with the

engine off.

3. Press

Q and K on the Remote Keyless Entry

(RKE) transmitter at the same time for

approximately five seconds. The horn sounds

twice to signal the receiver is in relearn mode and

TIRE LEARNING ACTIVE message displays on

the DIC screen.

4. Start with the driver side front tire.

5. Remove the valve cap from the valve cap stem.

Activate the TPMS sensor by increasing or

decreasing the tire's air pressure for five seconds,

or until a horn chirp sounds. The horn chirp, which

may take up to 30 seconds to sound, confirms that

the sensor identification code has been matched to

this tire and wheel position.

6. Proceed to the passenger side front tire, and

repeat the procedure in Step 5.

7. Proceed to the passenger side rear tire, and repeat

the procedure in Step 5.

6-32

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2010 Tahoe Spezifikationen Seite 88

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chevrolet 2010 Tahoe