Chevrolet 2012 Corvette Technical Information Seite 15

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 14
15
COUPE ROOF PANEL
Remove the Roof Panel
1. Lower the windows.
2. Pull each front lever (A) outward.
3. Press the button on the rear lever and
pull down the lever (B).
4. Lift the front edge of the panel up and
forward out of the roof opening.
Properly store the roof panel in the rear
storage compartment.
CONVERTIBLE TOP OPERATION
Before operating the convertible top, park the vehicle and make sure that the trunk
partition is in the fastened, upright position (Power Top only), and that the trunk is closed.
Operate the Power Top
1. Start the engine, shift to Park or Neutral, and set the parking brake.
2. Pull and turn the front latch clockwise to unlock the top; pull and turn it counterclock-
wise to lock the top.
3. Press and hold the bottom of the Power Folding Top button on the left side of the
instrument panel (see page 2) to lower the top; press the top of the button to raise the
top. A chime will sound when the top is lowered or raised completely.
Note: After a loss of battery power, initialize the window indexing to operate the power top.
Lower the Manual Top
1. Pull and turn the front latch clockwise to unlock the top.
2. Lift the front edge and the rear edge of the top so that they are straight up.
3. Press the release button under the tonneau cover behind the driver’s seat.
The windows will automatically lower. Raise the tonneau cover.
Note: The cover will not unlatch if the trunk is open or the vehicle alarm is armed.
4. Push forward on the front edge of the top to allow the rear edge of the top to move to
its full-down position. Then move the top rearward to its fully stored position.
5. Make sure that the top is fully retracted and close the tonneau cover.
See the Convertible Top Supplement or Keys, Doors and Windows in your Owner Manual.
Install the Roof Panel
1. With all levers in the open position, place the rear edge of the panel on the back of the
roof opening and align the pins with the openings in the weatherstrip.
2. Lower the front edge of the panel.
3. Turn each front lever (A) inward to lock the front latches.
4. Push up the rear lever (B) to lock the rear latch.
See Keys, Doors and Windows in your Owner Manual.
A
B
A
Seitenansicht 14
1 2 ... 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare