Chevrolet 1967CHEVY II Installationshandbuch PDF herunterladen (Seite 12)

8.2 TAIL/DOME SECTION CONNECTIONS

8.2.1 Take the DOME LIGHT SECTION and route it up from behind the drivers side kick

panel, up through the A-Pillar over to the dome light.

NOTE: If your dome

light wires are in good condition you can splice the new wires to the

original ones in the kick panel area.

8.2.2 Take the White wire on the Dome Light Harness and route it from the door jamb

switch on the drivers side along the bottom of the dash to the passenger side

door jamb switch. Connecting the white wires at the jamb switches and

connecting the headlight switch connector (wire at headlight switch connector

installed at factory) allows the dome light to be turned on when either of the

doors are opened or the headlight switch knob is turned.

Note: New door

jamb switches have been provided with the kit.

Figure 8.3 Fuseblock Mounted

Figure 8.4 Routing Dome Light Wires

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Keine Kommentare

Chevrolet 1967CHEVY II Installationshandbuch Seite 12