Chevrolet 1999 Express Van Spezifikationen PDF herunterladen (Seite 234)

Hitches

It is important to have the correct hitch equipment.

Crosswinds, large trucks going by and rough roads are

a few reasons why the right hitch is needed.

Weight-Distributing Hitches and Weight

Carrying Hitches

A: Body to Ground Distance

B: Front of Vehicle

When using a weight-distributing hitch, the hitch must

be adjusted so the distance (A) remains the same both

before and after coupling the trailer to the tow vehicle.

If a step-bumper hitch will be used, the bumper could be

damaged in sharp turns. Make sure there is ample room

when turning to avoid contact between the trailer and the

bumper.

If the loaded trailer being pulled will weigh more than

5,000 lbs (2 270 kg), be sure to use a properly mounted

weight-distributing hitch and sway control of the proper

size. This equipment is very important for proper vehicle

loading and good handling when driving. Always use a

sway control if the trailer will weigh more than these

limits. Ask a hitch dealer about sway controls.

Will any holes need to be made in the body of the

vehicle when a trailer hitch is installed?

If using the wiring provided with the factory-installed

trailering package, no holes need to be made in

the body of the vehicle. However, if an aftermarket hitch

is installed, holes may need to be made in the body.

If holes are made in the body, then be sure to seal the

holes later when the hitch is removed. If the holes are not

sealed, deadly carbon monoxide (CO) from the engine’s

exhaust can get into the vehicle as well as dirt and water.

See “Carbon Monoxide” under Engine Exhaust on

page 2-31.

4-34

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 409 410

Keine Kommentare

Chevrolet 1999 Express Van Spezifikationen Seite 234