Chevrolet 2000 Corvette Bedienungshandbuch PDF herunterladen (Seite 104)

2-46

Resuming a Set Speed

Suppose you set the cruise control at a desired speed and

then you apply the brake or clutch pedal. This, of course,

disengages the cruise control. But you don’t need to reset it.

Once you’re going about 25 mph (40 km/h) or more,

you can move the cruise control switch to R/A

(Resume/Accelerate) briefly. The Driver Information

Center (DIC) will display the cruise set speed.

You’ll go right back up to your chosen speed and stay there.

Increasing Speed While Using Cruise Control

There are two ways to go to a higher speed:

Use the accelerator pedal to get to the higher speed.

The speed will not begin to increase until sufficient

pedal travel is achieved. Push the SET button at the

end of the lever, then release the button and the

accelerator pedal. You’ll now cruise at the higher speed.

Move the cruise switch to R/A. parkHold it there

until you get up to the speed you want, then release

the switch. (To increase your speed in very small

amounts, move the switch to R/A briefly, then

release it. Each time you do this, the vehicle will

go about 1 mph (1.6 km/h) faster.)

The Driver Information Center (DIC) will display the

cruise set speed.

Reducing Speed While Using Cruise Control

There are two ways to reduce speed while using

cruise control:

Push in the SET button at the end of the lever until

you reach the lower speed you want, then release it.

To slow down in very small amounts, push the

SET button briefly. Each time you do this,

you’ll go about 1 mph (1.6 km/h) slower.

The Driver Information Center (DIC) will display the

cruise set speed.

Passing Another Vehicle While Using Cruise Control

Use the accelerator pedal to increase speed. When you

take your foot off the pedal, the vehicle will slow down

to the cruise control speed you set earlier.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 360 361

Keine Kommentare

Chevrolet 2000 Corvette Bedienungshandbuch Seite 104