Chevrolet 2005 Tahoe Wartungshandbuch Seite 30

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 42
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 29
Electrical Connections
Notice: Before modifying or adding any wiring,
be sure that it will work properly with your
vehicle’s wiring system. Because there are so
many modifications that can be made for many
different bodies and accessories, GM cannot take
responsibility for any changes made. Such changes
may not be covered by your GM Warranty. Have the
work done by an experienced electrical technician.
All wiring must be properly protected by fuses, etc.
and must be routed properly so that it will not be
cut, pinched or rubbed by other parts of the vehicle.
Do not route wiring in areas where it will be very
hot. Be sure not to overload the vehicle’s wiring,
connectors and components. All added wire must be
at least the same size as the wire being attached
to for proper fuse protection.
Installation Instructions 12-Volt
Accessory Power Supply
1. Disconnect the negative () battery cable at the
battery. The negative () battery cable must be
disconnected before the positive wiring lead
is connected to the power accessory.
2. Locate the power supply harness under the
instrument panel near the passenger’s side of the
vehicle. The wire bundle consists of the pink
ignition (IGN), orange battery (BAT) and black
negative (NEG) wire feeds.
3. Remove the tape to release the wire bundles from
the power supply harness.
4. Remove the 40 amp MegaFuse that is taped to the
wire bundle. Set aside for installation, after
equipment wiring is complete.
5. Prepare the wires that are to be used to connect
the power accessory. Do not remove the unused
wires. Tape unused wires back in their original
position under the instrument panel.
6. Complete the wiring installation of the customer
added accessory with additional wire required for
the specific electrical accessory power connection.
The wire gauge, 12 gauge (3.0 mm), should be
the same as the wiring of the installed harness.
14-4
Seitenansicht 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare