Chevrolet Impala 2007 Impala Wartungshandbuch PDF herunterladen (Seite 42)

TAHOE

Police Package is equipped with additional grounding in the following

locations:

1. Left hand front frame body mount bracket to underbody

2. Left hand rear frame body mount bracket to rear underbody

3. Right hand rear frame body mount bracket to rear underbody

4. Right hand center frame body mount bracket to center

underbody

5. Exhaust pipe hanger rod to rear frame hanger

1 2

RADIO SUPPRESSION

GROUND STRAPS

4 3 5

Power is supplied directly from the battery through a 50 amp circuit

breaker to a 10 gauge blunt cut wire coiled in a harness under the center

of the instrument panel. The 50 amp circuit breaker is connected through

a fusible link to a 125 amp mega fuse located near the Under-hood

Battery Electrical Center. Two 30 amp relay controlled circuits supply

power through 30 amp circuit breaker to blunt cut 12 gauge wires that are

part of the coiled harness. These 30 amp circuit breakers are connected to

the battery through a 60 amp mega fuse located in the same fuse block

with the 125 amp mega fuse. Each relay can be operated by connecting a

20 gauge control lead in the coiled harness to a power source. Two 20

gauge blunt cut wires provide ignition controlled power. One circuit in hot

when the ignition is in ACC or ON and the other is hot when the ignition is

in START or ON. Up to 100 amps (1200 watts) of power is available at the

instrument panel with these combined circuits.

The 50 amp and 30 amp circuit breaker and relays are located in a

Breaker/Relay center located forward of the instrument panel glove box.

The two 50 amp circuit breaker which protect the 100 amp auxiliary

power junction block in the rear compartment are also located in this

center. A 6 foot, 8 gauge ground wire is looped and is located under the

front passenger door sill plate for connection to customer equipment.

Also included in the coiled harness are two blunt cut signal wires. One cir-

cuit provides the Vehicle Speed Signal (VSS) and the second circuit

provides a 12 volt signal designed to operate a single customer furnished

relay when the Transmission is in PARK.

WIRING - IGNITION AND MAIN

POWER SUPPLY

EQUIPMENT GROUNDING STUDS -

REAR

CARGO AREA

Tahoe Police Package has grounding studs located at the lower left and

right hand rear compartment hatch opening for connection to customer

electrical equipment. A five foot blunt cut length of #8 awg copper wire

is coiled inside the jack stowage compartment to permit grounding of

electrical equipment which may be mounted forward in the rear

compartment and behind the second seat back.

DESCRIPTION OF STANDARD SPECIAL EQUIPMENT ON

TAHOE PPV 2-WHEEL DRIVE POLICE PACKAGE AND

5W4 4WD SPECIAL SERVICE PACKAGE

AUXILIARY POWER - REAR CARGO AREA

An auxiliary power junction block is located within the left side rear

cargo area jack sto

ge compartment.

This junction block is split to

provide two circuits for the connection to customer-furnished equipment

directly to the ba

tter

y through separate 50 amp circuit breakers, These

circuit breakers are loca

ted in the Breaker/Relay panel forward of the

instrument panel glove box. A maximum load of 100 amps (1200 watts)

can be connected.

The junction block s connected to a coiled 5 foot (1.5 m) branch of rear

body harness and fastened near the jack. Mounting of the junction block

can be at customer-selected rear cargo area loca

tions permitted by the

branch harness length and using customer-selected rear cargo area

locations permitted by the branch harness length and using customer

furnished mounting hardware. The junctions block should not be

attached to interior trim plastic components without appropriate backing

hardware for the mounting bolts.

RELEARN REMOTE KEY

o access this display

the vehic

le must be in P

ARK (P).

This display allo

you to match remote keyless entry transmitters to your vehicle. To match

a remote keyless entry transmitter to your vehicle, do the following:

1. Press the trip odometer reset stem until RELEARN REMOTE KEY

displays.

2. Press and hold the trip odometer reset stem for three seconds. The

message REMOTE KEY LEARNING ACTIVE will display.

Press and hold the lock and unlock buttons on the first transmitter

t the same time for a

pproximately 15 seconds. A chime will sound

indicating that the transmitter is matched.

o ma

tch additional transmitters a

t this time,

repea

t Step 3.

Each

vehicle can have a maximum of eight transmitters matched to it.

5. To exit the programming mode, you must cycle the key to LOCK.

REMOTE KEYLESS ENTRY

WITH REMOTE START

AND LIFTGLASS

(WITHOUT REMOTE SIMILAR)

WITH REMOTE START AND POWER

LIFTGATE AND LIFTGLASS

(WITHOUT REMO

TE ST

T SIMILAR)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet Impala 2007 Impala Wartungshandbuch Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chevrolet Impala 2007 Impala