Chevrolet Impala 2007 Impala Wartungshandbuch Seite 71

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 84
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 70
WIRING
71
WIRING Impala
Exterior Lamp Emergency Flashing System—SEO 6J7
SEO 6J7 provides a high-beam headlamps flashing module, rear lamps
flashing and control wire for a customer-furnished switch to turn the
module on or off. The flasher control wire is coiled in the passenger’s
side footwell under the instrument panel. This control lead may be
combined with the interior wiring leads for SEO 6J3 when that option is
ordered with SEO 6J7.
The headlamps flashing module is located at the inboard end of the
passenger’s side headlamps assembly. The headlamps flashing module
is activated by the application of 12 volts to a dark green/red wire
coiled in the passenger’s side footwell. When activated, the driver’s and
passenger’s side high-beam headlamps and the high-beam instrument
panel cluster light will flash alternately at 2.4 flashes per second.
During daylight conditions, the Daytime Running Lamps (DRL) are
automatically turned off whenever the headlamps flasher module is
activated. During nighttime conditions, the low-beam headlamps turn
on automatically while the high-beam headlamps flash. Turning on the
high-beam headlamps manually with the turn signal/multifunction lever
will override the flashing module and the high-beam headlamps will
operate continuously.
A fuse labeled HDLP MDL protects the flasher module circuit. This fuse
is located in the underhood fuse block in the engine compartment on
the passenger’s side of the vehicle. See “Fuses and Circuit Breakers” in
the Service and Appearance Care section of your Impala owner’s
manual for more information.
When the headlamps flashing module is turned on, the module sends a
signal to the Body Control Module (BCM). The BCM alternately flashes
the stop lamps and backup lamps. Depressing the brake pedal will
override the stop lamp flashing and placing the transaxle in reverse will
override the backup lamp flashing.
When it is dark outside, the taillamps will turn on automatically. The
Center High-Mounted Stoplamp (CHMSL) will not flash and will operate
only when the regular brake pedal is pressed.
HEADLAMPS FLASHER MODULE—SEO 6J7
Seitenansicht 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare